AR# 68897
|MIG 7 Series - Critical Warning during Synthesis of MIG Design with XC7S6 or XC7S15 Spartan-7 Devices
描述
Version Found: MIG 7 Series v4.2
Version Resolved: See (Xilinx Answer 54025)
When creating a MIG design with a XC7S6 or XC7S15 Spartan-7 FPGA there will be a critical warning message during synthesis:
CRITICAL WARNING: [Shape Builder 18-120] Failed to find a valid monitor site when building a shape for instance u_mig_7series_0/u_mig_7series_0_mig/temp_mon_enabled.u_tempmon/xadc_supplied_temperature.XADC_inst.
This error message is generated due to an error in Vivado where the MIG XADC option is enabled by default even though these two Spartan-7 devices do not have XADC instantiations.
解决方案
To avoid this error message, when configuring the MIG core with a XC7S6 or XC7S15 device, on the "FPGA Options" page make sure that the XADC Instantiation option is set to Disabled.
With other devices, the MIG IP requires an XADC instantiation in order to have temperature compensation for DQS gate tracking.
For these devices it is OK to have the XADC Instantiation disabled due to the low maximum data rates supported by these devices.
The expected behavior of the MIG Configuration GUI in future releases will be to not show the XADC Instantiation option for these devices and to have the IP set the option to Disabled.
Revision History:
09/13/2019 - Initial Release
链接问答记录
主要问答记录
| Answer Number | 问答标题 | 问题版本 | 已解决问题的版本 |
|---|---|---|---|
| 54025 | MIG 7 Series - IP Release Notes and Known Issues for Vivado | N/A | N/A |
| AR# 68897 | |
|---|---|
| 日期 | 09/13/2019 |
| 状态 | Active |
| Type | 已知问题 |
| 器件 | |
| Tools | |
| IP | |