I have Webtalk settings disabled, but when Vivado Simulator runs, it is still invoking Webtalk.
Built simulation snapshot design_1_wrapper_behav
****** Webtalk v2015.1 (64-bit)
**** SW Build 1215546 on Mon Apr 27 19:22:08 MDT 2015
**** IP Build 1209967 on Tue Apr 21 11:39:20 MDT 2015
** Copyright 1986-2015 Xilinx, Inc. All Rights Reserved.
source C:/projects_zynq/test/project_1/project_1.sim/sim_1/behav/xsim.dir/design_1_wrapper_behav/webtalk/xsim_webtalk.tcl -notrace
webtalk_transmit: Time (s): cpu = 00:00:00 ; elapsed = 00:00:06 . Memory (MB): peak = 67.344 ; gain = 0.438
while executing
"webtalk_transmit -clientid 3370217057 -regid "15770900_15770496_0_710" -xml C:/projects_zynq/test/project_1/project_1.sim/sim_1/behav/xsim.dir/design_..."
(file "C:/projects_zynq/test/project_1/project_1.sim/sim_1/behav/xsim.dir/design_1_wrapper_behav/webtalk/xsim_webtalk.tcl" line 41)
INFO: [Common 17-206] Exiting Webtalk at Mon May 11 13:13:40 2015...
run_program: Time (s): cpu = 00:00:01 ; elapsed = 00:01:08 . Memory (MB): peak = 973.645 ; gain = 0.000
INFO: [USF-XSim-4] XSim::Simulate design
INFO: [USF-XSim-61] Executing 'SIMULATE' step in 'C:/projects_zynq/test/project_1/project_1.sim/sim_1/behav'
INFO: [USF-XSim-98] *** Running xsim
All Webtalk settings are disabled, both at installation time and via the settings in Vivado.
Why does this occur and how can this be avoided?
This is a known issue where the standalone Webtalk feature used by XSIM does not stay in sync with the config_webtalk Tcl command.
There is no work-around available in Vivado 2015.1 but a fix is planned for Vivado 2015.2.
| AR# 64665 | |
|---|---|
| 日期 | 06/17/2015 |
| 状态 | Active |
| Type | 综合文章 |
| Tools | |