How do you configure the cross triggering between software and hardware (ChipScope) debug?
The debug configuration GUI in XPS tells me that there is no processor found that can co-debug with this IBA interface.
On the general settings GUI of the Zynq tab, I can enable the cross triggering signals of the Zynq PS, but the debug configuration GUI apparently does not recognize or cannot use these. Can I connect them manually, or how is this supposed to work?
Cross Trigger is not supported in 14.x, however, support should be added in 2013.1.
| AR# 53960 | |
|---|---|
| 日期 | 06/03/2013 |
| 状态 | Active |
| Type | 综合文章 |
| 器件 | |