For ML605 and SP605 Evaluation platform users, if your SanDisk 2GB CF card fails to configure the FPGA after pressing the System ACE Reset button, use the Power-switch instead:
1. Set the System ACE CF configuration address DIP switch to the desired address (Binary 0-7).
a. ML605: S1 "SACE MODE" 4-position DIP switch
i. Position 1-3: Configuration Address (LSB->MSB)
ii. Position 4: System ACE CF enabled when ON
b. SP605: S1 "SACE MODE" 4-position DIP switch
i. Position 1-3: Configuration Address (LSB->MSB)
ii. Position 4: System ACE CF enabled when ON
2. Power-cycle the Evaluation Platform.
3. Observe that the DONE LED is illuminated after the FPGA configures successfully.
AR# 34949 | |
---|---|
日期 | 05/20/2012 |
状态 | Active |
Type | 设计咨询 |
Boards & Kits |