AR# 16810: 3.1 System Generator for DSP - Release Notes and Known Issues List
AR# 16810
|
3.1 System Generator for DSP - Release Notes and Known Issues List
描述
Keywords: SysGen, MATLAB, Simulink, errata, KI
Urgency: Standard
General Description: What are the known issues for System Generator v3.1?
解决方案
Support Software Issues
1. MATLAB R12 and R12.1 are not supported by System Generator for DSP v3.1. (Only MATLAB R13 is supported.) Please see (Xilinx Answer 16827).
2. You need at least 5.1i Service Pack 3 with 5.1i IP Update 1. The recommended minimum install is 5.2i Service Pack 1. Please see (Xilinx Answer 16922).
3. Why do I get "libhsimengine.dll" and "libPortability.dll" when trying to open the Xilinx Block Set in MATLAB R13? Please see (Xilinx Answer 16928).
4. Why do I get an extra cycle of latency in my design when I use Synplify 7.2.2? Please see (Xilinx Answer 16934).
Xilinx Block Set Issues
1. The CIC filter exhibits overflow for inputs that use the complete dynamic bit range of the data input. To work around this problem, do not use the full dynamic range of your input. Please see (Xilinx Answer 12480).
2. Decimation filters with a down sampling of "2" and symmetry in the impulse response fail in core generation. Please see (Xilinx Answer 15685).
3. Updating a SysGen 2.1 model to SysGen 3.1 model causes errors. Please see (Xilinx Answer 16828).
4. PicoBlaze fails to compile when using the Leonardo synthesis tool. Please see (Xilinx Answer 16923).
5. PicoBlaze compiler script fails when using long module names. Please see (Xilinx Answer 16924).
6. The DDS fails to generate if Phase Dithering is selected and the Phase Angle is greater than the Phase Accumulator. Please see (Xilinx Answer 16927).
7. MAP reports errors when XST is used to synthesize a design containing the DDS core. Please see (Xilinx Answer 16935).
8. ROM Blocks for Spartan-3 fail to generate properly. Please see (Xilinx Answer 16926).
General Issues
1. The following error is reported during generation: "Undefined function or variable." Please see (Xilinx Answer 15190).
2. Updating from SysGen 2.1 to SysGen 3.1 causes an error in the xlUpdateModel script. Please see (Xilinx Answer 16828).