BRAM and Other Memories

The FPGA fabric includes embedded memory elements that can be used as random-access memory (RAM), read-only memory (ROM), or shift registers. These elements are block RAMs (BRAMs), LUTs, and shift registers.

The BRAM is a dual-port RAM module instantiated into the FPGA fabric to provide on-chip storage for a relatively large set of data. The two types of BRAM memories available in a device can hold either 18k or 36k bits, and the available amount of these memories is device specific. The dual-port nature of these memories allows for parallel, same-clock-cycle access to different locations.

In OpenCL code, BRAMs can implement either a RAM or a ROM, covering on-chip, local, and private memory types. In a RAM configuration, the data can be read and written at any time during the runtime of the circuit. In contrast, in a ROM configuration, data can only be read during the runtime of the circuit. The data of the ROM is written as part of the FPGA configuration and cannot be modified in any way.

As previously discussed, the LUT is a small memory in which the contents of a truth table are written during device configuration. Due to the flexibility of the LUT structure in Xilinx FPGAs, these blocks can be used as 64-bit memories and are commonly referred to as distributed memories. This is the fastest kind of memory available on the FPGA, because it can be instantiated in any part of the fabric that improves the performance of the implemented circuit.

Figure: Structure of an Addressable Shift Register

The shift register is a chain of registers connected to each other. The purpose of this structure is to provide data reuse along a computational path, such as with a filter. For example, a basic filter is composed of a chain of multipliers that multiply a data sample against a set of coefficients. By using a shift register to store the input data, a built-in data transport structure moves the data sample to the next multiplier in the chain on every clock cycle.