fpga
Configure FPGA.
Syntax
fpga <bitstream-file>
Configure FPGA with given bitstream.
fpga [options]
Configure FPGA with bitstream specified options, or read FPGA state.
Options
| Option | Description |
|---|---|
| -file <bitstream-file> | Specify file containing bitstream. |
| -partial | Configure FPGA without first clearing current configuration. This options should be used while configuring partial bitstreams created before 2014.3 or any partial bitstreams in binary format. |
| -no-revision-check | Disable bitstream vs silicon revision revision compatibility check. |
| -skip-compatibility-check | Disable bitstream vs FPGA device compatibility check. |
| -state | Return whether the FPGA is configured. |
| -config-status | Return configuration status. |
| -ir-status | Return IR capture status. |
| -boot-status | Return boot history status. |
| -timer-status | Return watchdog timer status. |
| -cor0-status | Return configuration option 0 status. |
| -cor1-status | Return configuration option 1 status. |
| -wbstar-status | Return warm boot start address status. |
Note(s)
- If no target is selected or if the current target is not a supported FPGA device, and only one supported FPGA device is found in the targets list, then this device will be configured.
Returns
Depends on options used.
-file, -partial: Nothing, if fpga is configured, or an error if the configuration failed.
One of the other options Configutation value.